ASTM C773 PDF

Purchase your copy of ASTM C – 88() as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. Designation: C − 88 (Reapproved ) Standard Test Method for For referenced ASTM standards, visit the ASTM website, , or. Find the most up-to-date version of ASTM C at Engineering

Author: Voodoot Faerr
Country: Paraguay
Language: English (Spanish)
Genre: Finance
Published (Last): 15 May 2016
Pages: 469
PDF File Size: 17.18 Mb
ePub File Size: 12.55 Mb
ISBN: 415-4-51010-214-1
Downloads: 28451
Price: Free* [*Free Regsitration Required]
Uploader: Yonos

Suitable materials for cushion pads, selected in accordance with the compressive strength range of the material being tested, are shown in the following table: Significance and Use 3.

The spherical surfaces shall be well lubricated, and the center of curvature shall lie on the lower face of the platen. Last previous edition C — 88 Ideally, ceramics should be stressed this way in use. They may be formed and matured for the purpose of compression testing, or they may be cut from matured whitew- are by sawing or coredrilling. A number in parentheses indicates the year of last reapproval. The compo- nents of variance for compressive strength results expressed as coefficients of variation were calculated as follows: NOTE 1—It is desirable to include details of the origin of the specimen and subsequent treatment.

  BROMHIDROSIS TREATMENT PDF

ASTM International – Laboratory Directory – University of Dayton Research Institute

Precision and Bias 8. This test is a measure of the potential load-bearing usefulness of a ceramic. Single-operator component Between-laboratory component 1. If the contact block asmt cracked during testing, it shall be replaced.

The ends of all specimens shall atm ground or lapped to yield plane and parallel faces. It is the responsibility of the user of this standard to establish appro- priate safety and health practices and determine the applica- bility of regulatory limitations prior to use.

ASTM C773 – 88(2016)

These faces shall be perpendicular. New cushion pads shall be used for each specimen. A superscript epsilon e indicates wstm editorial change since the last revision or reapproval. C — 88 Reapproved Standard Test Method for Compressive Crushing Strength of Fired Whiteware Materials1 This standard is issued under the fixed designation C ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

  LIBERAL LIBERTRIO LIBERTINO PDF

Originally published as C — 74 to replace C and C C 5 compressive strength of the specimen, psi or MPa; P 5 total load on the specimen at failure, lbf or N; and A 5 calculated area of the bearing surface of zstm specimen, in. Discard any pieces exhibiting cracks or flaws visible to the unaided eye.

Place an appropriate guard around the specimen to contain flying fragments at failure; eye protection should be used by the operator. Enviado por Thamyres flag Denunciar. One operator in each laboratory tested ten specimens of each material.

Current edition approved Sept.